Ice Water Splash Test Chamber
1. Introdution
The splash water test chamber meets the requirement of ISO16750-4 clause 5.4.2. It can be used for splash water or high temperature test alone, to simulate ice water splashing over a hot system or components when driving on wet roads in the winter. Failure modes are mechanical cracking of materials or seal failures caused by different temperature expansion coefficients. I’ts a reliability testing equipment for cold resistance, heat resistance, ice water splash resistance test and quality control engineering of various electronic, electrical, plastic and other raw materials and devices.
2. Specification
Outer size (L*W*H) | 1500*1900*2250 (mm) |
Inner size (L*W*H) | 1000*1000*1000 (mm) |
Number of nozzle | 1pc |
Nozzle position | Right side of inner chamber |
Distance nozzle to device under test | (325±25) mm (munally adjust) |
High temperature range | RT +10℃~150℃ |
Heating rate | RT +10℃~150℃ ≤ 45min |
Splash water temperature | 0℃~+4℃ |
Cooling rate | +25℃~2℃≤ 60min |
Water flow | (3~4)L/3s |
Test liquid | De-ionized water or +3% Arizona fine dust |
Injection time per cycle (30min) | 3s, interal time:29min57s (touch screen setting) |
Number of shocks (cycles) | 100 cycles (touch screen setting) |
Working power | 380V/50Hz (3 phase 4 wires+ protective ground) |
Power | 12.0KW |