Auto Cable Sandpaper Abrasion Test Apparatus
The auto cable sandpaper abrasion test apparatus meets the requirements of ISO6722-1 clause 184.108.40.206 figure 6, GB/T25085, QC/T730, JASO D608, JASO D611, SAE J1127, SAE J1128 and JIS C3406 standard. It’s applied for verify that the resistance of the cable insulation to sandpaper abrasion.
Measure the “resistance to sandpaper abrasion” using 150J garnet sandpaper tape with 5mm to 10mm conductive strips perpendicular to the edge of the sandpaper spaced a maximum of every 75mm. Exert a force of (0.63±0.05)N on the test sample by the combination of the bracket, support rod and pivoting arm, draw the sandpaper abrasion tape under the test sample at a rate of (1500±75)mm/min and record the length of sandpaper abrasion tape necessary to expose the conductor. Move the test sample 50mm and rotate the test sample clockwise 90°. Repeat the procedure for a total of four reading. The mean of the readings shall determine the resistance to sandpaper abrasion.
1, each time test one sample
Test Sample size
Diameter ≤8mm, length 1m
Left and right clamps, distance between clamp is 700mm
150J garnet sandpaper tape, total length 5m, width 20mm
Speed of sandpaper tape
100mm/min and 1500mm/min selectable
Sandpaper tape abrasion travel
Angle between sandpaper tape and sample
Support rod + bracket=64.26g, randomly equip with 50g, 150g, 450g, 950g and 1450g weight (or can be customized)
AC 220V, 0.5KW