Category
Product Detail
Share to:

Spillage Test Apparatus

 
Detail
Description The spillage test apparatus meets the requirements of IEC60335-2-15 clause 15.2 and figure 101 Model PG-SGA

Spillage Test Apparatus

1. Introduction:

The spillage test apparatus meets the requirements of IEC60335-2-15 clause 15.2 and figure 101. It’s used to check the connectors with spillage protection to ensure that the connectors are not affected by liquids when installed in a rated voltage base according to the manufacturer’s installation instructions.

The spillage test is carried out with the appliance deviating from the normal position of use by an angle not exceeding 5°. The kettles are placed on a plane inclined at an angle of 20° to the horizontal and 30ml of water containing approximately 1% NACL is poured onto the top rim in the most unfavourable place. The solution is poured steadily through a tube having an inner diameter of 8mm over a period of 2s, the lower end of the tube being 200mm above the appliance. A further quantity, equal to 15% of the rated capacity of the kettel, is then added as quickly as possible.


2. Parameters:

Tube dimension

Inner diameter: Ø8mm, length 3mm

Distance   between the lower end of the tube and specimen

200mm

Water injection method

Double water injection pipes, one for tap water, and the other for salt water

Flow control

Manual control

Lifting method

Manual screw adjustment of the lifting table


Contact us

PEGO ELECTRONICS (YI CHUN) CO., LTD.

ADDRESS: No. 429, Yichun South Road ( Happiness Park),   Yuanzhou District, Yichun, Jiangxi, 336000, China

E-MAIL: sales@pegotester.com, salesHK@pegotester.com

              service@pegotester.com

WEB: https://www.pegotester.com h‍ttps://www.pegotesters.com

TEL: 86-(0)795-3560528   FAX: 4008266163 ext. 29929

CS
 
 
website qrcode

Mobile Website