Tumbling Barrel
1. Introduction
The tumbling barrel is designed according to IEC60335-2-17 clause 21.107 and Figure 107. It’s used for the mechanical strength test of supply cords of pads. Cut off the pad’s supply cords at a distance of 100mm from the flexible part and put it into the tumbling barrel, the barrel is turned at a rate of 6rpm to 7 rpm for 500 revolutions, the specimen falls onto the steel plate twice in each revolution.
2. Parameters
Control way | Button control+meter |
Roll speed | 6rpm to 7rpm |
Falling height | 1975mm |
Test station | 1 |
Structure | Equip with rubber bevel |
Materials (on both bottom) | 3mm steel plate+ wooden support >19mm |
Number of tests | 0-999999 (settable) |
Range of roll speed | 1-60 rpm (settable) |
Power supply | 220V/50Hz |
Dimension | 1000*1300*2200mm (L*W*H) |
